Download >>> https://shurll.com/2svROM
June 3, 2009 — eroticid wrote: Hi Sasha, I want to use DD-WRT on the ubiquiti device, is it possible to activate super channel for bullet 2? what software is dd-wrt. cfg should this be enabled if it is possible in terms of signal quality? It is possible without a superchannel, only with a lower speed. It is possible without a superchannel. But as a rule, in this case, the speed drops very much. In my case bullet 2 is the second access point. I don't use superchannels at all. If you need a superchannel, then I would advise you to put the access point in bridge mode (MIMO 2x2). In this case, it will be possible to connect two access points to it, and get two independent networks. 29a7f46325
Download >>> https://shurll.com/2svROM
June 3, 2009 — eroticid wrote: Hi Sasha, I want to use DD-WRT on the ubiquiti device, is it possible to activate super channel for bullet 2? what software is dd-wrt. cfg should this be enabled if it is possible in terms of signal quality? It is possible without a superchannel, only with a lower speed. It is possible without a superchannel. But as a rule, in this case, the speed drops very much. In my case bullet 2 is the second access point. I don't use superchannels at all. If you need a superchannel, then I would advise you to put the access point in bridge mode (MIMO 2x2). In this case, it will be possible to connect two access points to it, and get two independent networks. 29a7f46325